Gear change control

5 -	Gear change control

1	Gear change lever pin

2	Gear change pedal

3

4	Rubber block for pedal

5

6

7

8	Actuating rod

9

10

11

12

13

14

15

Parts catalogue


1100	l.h. foot rests
1100S	l.h. foot rests

Bold reference numbers in this section identify parts shown in this exploded view diagram. These parts do not appear in the figures near the text.

Removing the gear change control

Unscrew and remove the pivot bolt (1) of the gear change pedal (2).

Unscrew and remove the screw (10) securing the lever to the gearbox shaft.

Withdraw the lever (12) together with the gear change control assembly.

Mark lever (12) position relative to the gear selector shaft.

Loosen screw (11) to remove the lever (12) from gear change control unit. Keep nut (14) and remove lever (12) from joint (13).

Disassembling the gear change control

Please refer to the exploded view at the beginning of this section for indications on disassembly and replacement of gear change control components.

If the bush (6) inside the pedal (2) needs replacing, drive the replacement bush in place using a press. The bush must be seated 2 mm deep below the pedal outer face.

After servicing the gear change control, check the gear change pedal position.

To adjust the gear change pedal, follow the instructions provided in Sect. D 4, Adjusting the position of the gear change and rear brake pedals.

Refitting the gear change control

To refit, reverse the removal procedure.

Be sure to grease the two O-rings (5), apply threadlocker to screw (10), pin (1) and screw (11) and then tighten them to the specified torque (Sect. C 3, Frame torque settings).